High Heat Transfer Efficiency Copper Brazed plate heat exchanger
for steam heating BL120 (Swep B120 replacement)
1.Plates:Stainless Steel AISI 316L
2.Connections: Stainless Steel AISI 316L
4. Cover plates: Stainless steel AISI 316L
Brazed plate steam heater – flow principle
The main components are the same as for the evaporator. The
refrigerant enters at top left of the exchanger as
hot gas and starts to condense on the surface of the channels until
fully condensed, and is then slightly subcooled.
The process is called "free condensation". In the enclosed
condenser picture the light and dark blue arrows show
the location of the brine connections. The refrigerant flows
counter current in the opposite channel and is cooled.
The light and dark red arrows indicate the locations of the
The plate pack is covered by cover plates. Connections are located
in the front or rear cover plate. The channel plates
are corrugated to improve heat transfer efficiency and to make them
Particulars required for quotation
To enable Baode's representative to make a specific quotation,
enquiries should be accompanied by the following
– flow rates or heat load required
– temperature program
– physical properties of liquids in question
– desired working pressure
– maximum permitted pressure drop
Advantages of brazed plate heat exchangers in Industry and
The Baode Brazed plate heat exchangers (BHE) have several
advantages over traditional heat exchangers in Industrial
and HVAC&R applications.
– The high heat transfer efficiency of the BHE makes it extremely
compact and also easy to install in places were
space is limited.
– The unit has no gaskets and is therefore suitable in applications
were temperature and/or pressure is high e.g. in
– The Baode supply system reassures that, no matter were you are on
the globe, the BHE units are available with a
very short delivery time.
Short delivery time.
Know-how design and customer support